back To Top
ภาษา

Flower Brooch using Embroidery Stitching Tool

picture

ออกแบบโดย

Mayumi Yonenaga

Materials

・20-cm square of fabric in a green color

・Darning thread (in yellow

・Embroidery thread in 6 colors of your liking

・A 3.5-cm square of felt

・Brooch pin (25 mm)

・Thread for sewing by hand


เทมเพลต

Flower_Brooch_using_Embroidery_Stitching_Tool_template_enのサムネイル
icon

ไฟล์รายการ (pdf)

IC-E-185_Flower_Brooch_using_Embroidery_Stitching_Toolのサムネイル
icon

วิธีทำ

1

Use tracing paper to transfer the design to the fabric, then place the fabric in a hoop.

2

Place a 6-ply needle head in the Embroidery Stitching Tool and use it to embroider in line with the design.

3

Remove the fabric from the hoop and cut it to a size that leaves a margin of about 5–7 mm.

4

Fold the margin section back and glue it in place.

5
picture

Cut the felt in line with the template.
Place the felt on the back. If any felt can be seen when looking at the front of the brooch, cut it off.

6
picture

Sew the brooch pin on and glue it to the back to complete the brooch.

picture

7

How to embroider the flowers

picture

・Embroider all sections using a 6-ply needle.
・Embroider in the order of (1)–(3).

(1)
・Needle length: position 3
・Darning thread: 3-ply thread*
・After making loop stitches, apply glue to hold them in place, and once it has dried, cut the loops to make a velvet-like finish

(2)
・Needle length: position 3
・No. 25 embroidery thread: 6-ply thread
・Loop stitch

(3)
・Needle length: position 0–1 (Adjust to your liking)
・No. 25 embroidery thread: 6-ply thread
・Loop stitch